Limiting the area of the geometry?

Post Reply
nirsul
Posts: 5
Joined: Fri Oct 30, 2009 3:33 pm

Limiting the area of the geometry?

Post by nirsul »

Hi

Just bought it and was wondering - Is there a way to force SL to create the topography within the boundaries of my plan -

If I have topo-lines within a rectangle - SL creates a big mesh which does not respect the rectangle - This is annoying since I have to cut out any residual mesh areas.


Regards

NIR
anvar
Posts: 552
Joined: Sun Jul 11, 2010 12:34 pm

Re: Limiting the area of the geometry?

Post by anvar »

readme
Posts: 1
Joined: Thu Jul 18, 2013 6:30 pm

Re: Limiting the area of the geometry?

Post by readme »

I've got the exact same question, but the mentioned thread isn't available anymore.
Also as a side note, how do I prevent SplineLand from generating terrain below Z=0 within a closed spline whose control points are all at Z=0?
My workaround right now is putting even more smaller splines in those areas.

Thanks!
readme
anvar
Posts: 552
Joined: Sun Jul 11, 2010 12:34 pm

Re: Limiting the area of the geometry?

Post by anvar »

readme wrote:I've got the exact same question, but the mentioned thread isn't available anymore.
Also as a side note, how do I prevent SplineLand from generating terrain below Z=0 within a closed spline whose control points are all at Z=0?
My workaround right now is putting even more smaller splines in those areas.

Thanks!
readme
please send us the file and some screenshots to mail@rendering.ru to troubleshoot
thank you
Anvar
Post Reply